Rig Oil Field

Pure aluminium naturally forms a tough resistant oxide, almost immediately that protects it from further oxidation in most environments. Aluminium alloys, however, offer little protection against corrosion. There are three main ways to passivate these alloys: alclading, chromate conversion coating and anodizing. Alclading is the process of metallurgically bonding a thin layer of pure aluminium to the aluminium alloy. Chromate conversion coating is a common way of passivating not only aluminium, but also zinc, cadmium, copper, silver, magnesium, and tin alloys. Anodizing forms a thick oxide coating. This finish is more robust than the other processes and also provides good electrical insulation, which the other two processes do not.

IN general practice prior to storing hydrogen peroxide in an aluminium container, the container can be passivated by rinsing it with a dilute solution of nitric acid and peroxide alternating with deionized water. The nitric acid and peroxide oxidizes and dissolves any impurities on the inner surface of the container, and the deionized water rinses away the acid and oxidized impurities.
 

RXSOL-15-2001-NO is the more effective product and is used to remove mineral / lube / Rubber oil based products. When using RXSOL-15-2001-NO, the flash point of the actual needs to be greater than 60* c .If the flash point is below 60* c , the tanks should be inserted .

Spraying - Following rough washing to a good Water White or better, apply dilute Bleach to 1 - 3% strength.  First wet the tank surface (spray with DI water), then spray all over with Bleach, wait 30 minute (but do not allow to dry) and then rinse very well with DI water, including the tank top towards the sump.  To ensure that you have covered all areas properly, this process should be carried out at least twice with good DI water.

Injection - no.

Re-circulation - Following rough washing  to a good Water White standard or better, apply dilute Bleach to 1-3% strength.  Mix sufficient Bleach with fresh water in the tank and heat this mixture to 40 - 50 0 C, circulate through the drop line if fitted and than circulate through butterworth machine for 3 hours.  After re-circulation immediately warm butterworth to (500 C) the tank for 3 hours at maximum pressure, increase the water temperature to 80-85 o C after 45 minutes.  Check (by smell) that there is no Bleach remaining, then fresh water rinse and dry.

** When there are a number of tanks requiring re-circulation, it may be significantly more efficient to make up a large batch or number of batches that can be transferred on between  tanks as required.

* Use a strainer at the pump stack when circulating any solution.
Tank Lining - Stainless / Zinc / Epoxy / Phenolic (Extreme care must be taken if product other than bleach substitute is to be used in any coated space).
 

Scales remover for sewage pipe lines and evac systems.
 

Reason for DRAIN BLOCKAGE :

Frequently chopped food particles gets jammed and clogged in the entrance of the pipes and produces wreckage that effects the regular flow of water resulting in foul smell.

The washbasins of house are of regular use, and often many dirt particles like hairs and residue of food particles blocks the exhaust pipes.
 

Result :::

Trapped dirt material s after time causes stinking smell attracting cockroaches, Suitable for for any type of metal (except for soft metal like aluminium and zinc)