Dose Direction of ACC9
Depending upon contamination dilute concentrate with 10-25% with fresh water. In general terms take 1 Ltr concentrate and mix with 3 ltrs fresh water. For effective cleaning of air coolers, scavenging air systems and turbo chargers of diesel engines. As practical we observed that for engine capacity upto 12000 HP, 2 -3 ltr mixed diluted solution can be circulated for approx 10 - 15 minutes, Then followed by fresh water rinsing. While with higher and more engine power like engine power upto 24000 HP cleaning solution upto 5 ltrs while for engine power more then 24000 HP, 6 Ltr diluted cleaning solution required. . After uses of cleaning solution flushing with fresh water to clean complete emulsified deposit is a wise decision.
Otherwise doses can be calculated as per surface area. 3 to 5 litres of cleaning solution per square meter.
In
Hand spray Cleaning: By Hand spray, apply concentrate RXSOL-16-0009 all over the cooler coils. for good emulsification &penetration. Allow the RXSOL-16-0009 for a minimum of 10 MINUTES then use a high
Immersion bath
Soak method: Machine parts with stubborn carbon deposits to be cleaned is dipped into
Circulation method
Some designs of cooler can be circulated "in situ". In this case a pump tank and pipe system is fitted permanently or connections are provided for connecting a temporary circuit. The system should be filled with AIR COOLER CLEANER circulation carried out for 2 - 4 hours at a temperature of
Note: Both cleaning methods benefit from
Products:
- Add new comment
- 3547 reads