Air Cooler Cleaning Chemical
Air Cooler Cleaning Chemical (RXSOL-16-0009-020)
Cleaner for Air Coolers and Turbo
Product Description: RXSOL-16-0009-020 is a concentrate solvent emulsion cleaner for cleaning of Air coolers, Scavenging air systems and turbochargers of diesel engine.
Proced Ure of Use: In-service cleaning–RXSOL-16-0009-020 is passes through the air trunking upstream of the charge aircooler, followed by a clean water rinse.For cleaning of air coolers, it is necessary to use correctly installed dosing and injection system.
Dose : 3 to 5 litres of cleaning solution per square meter or as table below:
Engine HP. | Solution of 10 to 25% RXSOL-16-0009-020 |
6,000 to 12,000 | 2 to 3 litre |
12,000 to 24,000 | 4 to 5 litre |
24,000 or more | 6 litre |
Application
Immersion bath
Atleast for 2 Hrs deep COOLER PARTS in to AIR COOLER CLEANING CHEMICAL emulsion tank. The product should be heated to approx. 50°C and agitation provided with an air line. Then drain off and flush well with water, followed by drying with an air line.
Soak method: Machine parts with stubborn carbon deposits to be cleaned is dipped into conc.Soln.of ACC then allow deposits to. Be broken down and loosened before removal, then rinse .
Circulation method
Some designs of cooler can be circulated "in situ". In this case a pump tank and pipe system is fitted permanently or connections are provided for connecting a temporary circuit. The system should be filled with AIR COOLER CLEANING CHEMICAL circulation carried out for 2 - 4 hours at a temperature of upto 50°C. After cleaning the cooler should be thoroughly flushed with fresh water and dried with an air line.
Note: Both cleaning methods benefit from heat of up to 50°C and cleaning times can be reduced or extended dependant on temperature and degree of fouling.
Hand spray Cleaning: By Hand spray,apply concentrate RXSOL-16-0009-210 all over the cooler coils. for good emulsificati-on &penetration. Allow the RXSOL-16-0009-210 for a minimum of 1 hour,then use a high pressu ure water to wash off the loosened deposits. During process always keep drain valve open. After satisfactory cleaning, and flushing through with fresh water, close air cooler drains.Note that during this process the engine must be stopped.
Characteristics:-
. Formulated to remove oil,grease & carbon deposits from air coolers & scavenging system
. Efficient and economical.
. May be used for in-service cleaning.
. Renders surfaces oil-repellent.
. Maintains and stabilizes air cooler efficiency at maximum.
. Saves time, maintenance costs and avoids risks of damage when dismantling.
. Leaves no residue and has no harmful effect on engine.
. Product in water solution is non-flammable, non-explosive and has no flash point.
. Can be used for light carbon removal from machinery parts
**Read the Material Safety Data Sheet before using this product**
Product: