Product Notes
- 7817303 reads
Directions for use :
Corroision Inhibitor for METALis best fed neat from the drum continuously to the water used to fill the tank or system. Strict proportioning is not required, so long as the turbulence on filling is sufficient to provide effective distribution throughout the system. Where the system to be treated is already full and draining and refilling is impractical, distribution of the Ballast Tank. Corroision Inhibitor for METAL in an open vessel can be achieved by air-agitation or pump circulation. Ballast Tank.Corroision Inhibitor for METAL is recommended for systems in which dissolved oxygen is present and the use of air to encourage mixing will not impair corrosion protection.
Dosing an Control :
The recommended initial dosage of Ballast Tank Inhibitor 9-933 is 100mls.ton of water. This will provide 2 to 4ppm zinc in the water system. For Ballast tanks or systems which are frequently emptied and refilled, the initial charge of 100ml per ton of water should be supplemented by a dosage of 50ml per ton each time the system is refilled.
Corroision Inhibitor for METAL Ballast Tank resulting film formation and provide Zinc ppm level inside the Ballast Tank. It contains no chromates and is completely soluble in sea water. Corrosion Inhibitor for Ballast Tank.
RXSOL-23-2901-025 is film-forming corrosion inhibitor. RXSOL-23-2901-025 is useful for Ballast Tanks, Bilges, Voids, Cofferdams and Barges.
Features & Benefits :
- Effective for use in ballast tanks, cofferdams, barges and voids
- Forms tightly bonded protective film on all metal surfaces below water level
- Protective film is stable over a wide pH and temperature range
- Formulated to give reduced pollution problems if accidentally discharged to sea
- Ideally suited for ballast and other tank protection during ship lay-up periods
