Product Application
- 8123335 reads
ON-LINE CLEANING
Is normally performed by mixing one part RXSOL ORG 80 concentrate with 1:4 parts of water into a stable solution. RXSOL ORG 80 -Super Concentrate is to be mixed in a 1:19 dilution. Use demineralised water as specified by the engine manufacturer, typically <11µS/cm. The volume of chemical solution needed per wash and the optimum cleaning frequency will depend upon engine size, operating environment and fouling tendency. It is recommended that a post rinse is performed to ensure that the nozzle system is cleaned and ready for next operation.
OFF-LINE, CRANK WASHING
Concentrated RXSOL ORG 80 is normally mixed with 1:4 parts of good quality water. RXSOL ORG 80 Super Concentrate is to be mixed in a 1:19 dilution. The solution is injected at cranking speed, allowed to soak for 20 to 30 minutes then thoroughly rinsed off at cranking speed with good quality water acceptable to the engine manufacturer. RXSOL ORG 80 can be used without dilution for offline cleaning, providing a superb cleaning result for heavily fouled compressors.
ANTIFREEZE
Add antifreeze below +10ºC, RXSOL ORG 80 is compatible with Methanol, Propylene Glycol, Ethylene Glycol. Rx Marine International manufacture a superior freeze point depressant, RXSOL Antifreezing Liquid, please contact Rx Marine International for further information.
RXSOL ORG 80 can be used with any on-line/off-line injection system but for optimum cleaning results and economic usage of chemicals, Rx Marine International offers a full range of patented manual or fully automatic atomising injection systems to suit any engine type.
FEATURES and BENEFITS
- Safely and effectively cleans compressors on-line when running at any speed and load.
- Extremely effective non-solvent cleaner.
- Meets the most stringent requirements of gas turbine manufacturers.
- Ideal for light and frequent on-line washing of any type of industrial, marine or aviation gas turbine to maintain in-service output and fuel efficiency.
- On-line cleaning reduces damaging shutdown/start-up thermal cycles and starter wear and tear.
- Ideal for off-line cleaning due to high biodegradability.
- Non-flammable.
- Mixes readily with most antifreeze agents to allow low ambient temperature on-line/off-line cleaning.
- Supplied in concentrated form to reduce transport and handling costs and minimise storage requirements.
- Can be supplied as wipes for cleaning many other gas turbine part .
SAFETY AND HANDLING
| Hazard Rating | : Xi. Irritant |
| US NFPA Rating | :1,1,0 |
| Protective | :Non-hazardous but avoid frequent prolonged direct contact with skin to prevent |
| Measure | : Possibility of de-oiling skin and wear eye protection as a matter of course when handling any chemical |
| Spillage | :Absorb large spillages with sand or earth. Flush away small spillages with water |
| Fire | : Non Flamable |
| Eyes | :Flush liberally with water. If any irritation persists seek medical attention. |
| Skin | :Wash skin with soap and water. |
| Inhalation |
:Remove patient to fresh air. If rapid recovery does not occur obtain medical attention. |
IMPORTANT ECOLOGICAL NOTES
RXSOL ORG 80 is a safe and highly biodegradable chemical. However for off-line, crank-wash cleaning all chemical solution and rinse water drainage should be collected and disposed of properly no matter what type of chemical (Solvent based or detergent based) is being used. Always adhere to the local & national regulations.
